FAQ

The biggest difference is the chemical composition. GS30 belongs to Chloroprene rubber, while silicon made from siloxane.
GS30 is cured by volatilization of solvent (fast curing), and GS30 contains solvent;
Silicone does not contain solvent, and it is cured by moisture in the air (curing slowly).
In terms of function, GS30 contains oily (solvent) rubber components, so compared with silicon, GS30 has excellent adhesion, toughness, weather resistance and others.
GS30 is suitable for vehicle repair or outdoor adhesion; the DIY or general decoration will use silicon.

When the building has concrete peeling, exposed reinforced rebar and cracks, it represents that the building structure has been damaged. Under the safety reasons, it is recommended to carry out structural reinforcement.
Common reinforcement methods: crack reinforcement, carbon fiber reinforcement, steel plate reinforcement, expanded column shear wing wall and shear wall.

In the past, traditional super glue contained benzene (toluene, xylene) or formaldehyde solvent, being in such an environment for a long time will have an impact on human health. Therefore,
Kuo Sen Company has developed environment-friendly products, which do not use benzene or formaldehyde, and have passed the SGS test. Kuo Sen ensures constructors, as well as end users, have healthy and non-toxic living space.

If you accidentally touch your hands or skin, please wash it with soap water or polish it with Nail
Polish Remover as soon as possible.
If it has hardened and cannot be cleaned, the glue will naturally fall off due to metabolism.
If the fingers have stuck to each other, please soak them in hot water (about 50 ℃) and slowly extend and open the fingers will be fine.

It can be diluted by adding a little toluene. Please pay attention to the dosage. If it is too much will affect the quality of the adhesive. If it has been completely hardened after exposure to air, it is not recommended to use it.

It can be diluted with a little water. Please pay attention to the dosage. If it is too much will affect the quality of the adhesive.

Please turn off the water switch first, dry the water, and scrape off the rust impurities.
※ if watery or wet surfaces, It is recommended to use our special Epoxy putty clay that can be used in water. Please see the video linking: 連結至Youtube影片

GS30 Strong Adhesive sealant is elastic and impact resistant after curing. The temperature resistant will be based on different bonding materials. Generally speaking, GS30 can withstand temperature up to 100 ℃ in a short time (~4 hours), so it can be used in the housing water heater pipeline. In case of high temperature or industrial applications, please test the feasibility first.

Wall efflorescence paint is in liquid and is coated with brush. The efflorescence paste is thick after mixing and needs to be applied with a scraper.
It is recommended to use wall efflorescence paint as primer, and then apply a layer of wall efflorescence paste, that will have better effect.

The Calcium Silicate Sealant is a dual liquid mixed material, which has strength after hardening and is used to fill the gap and joint between calcium silicate boards, no cracking will occur after hardening. General Render Paste is a single agent of water-based material, which has no strength after the moisture volatilization and hardening. General Render paste cannot be used to filling the joints on the calcium silicate board surface, but can only be used to fill and level the concrete surface.

It is recommended that the bottle cap should be tightened after use, put in the zipper bag and stored in the refrigerator, can prolong the shelf life.

Double liquid epoxy resin is not mixed in volume ratio, but in weight ratio. Please weigh the main agent (agent A) and hardener (agent B) with equal weight and fully mix them for use.